3M Steri-Vac GSX Series - Operating Instructions

56
3M
™
Steri‑Vac
™
Sterilizer / Aerator GSXSeries – Operator’sManual
13. OperatingInstructions
13.1. Starting aCycle
The Operator controls the 3M™Steri‑Vac™ Sterilizer/Aerator GSX Series via a touch screen. A fingertip, stylus, or ball tip pen can be safely used to navigate the touch screens. There are seven
(7) programming steps to start acycle.
DANGER: To reduce the risks associated with exposure to ethylene oxide,
inspect the display screen and cycle reports for errors and listen for audible notifications (if enabled). Always take action for errors as indicated in this manual.
CAUTION: To reduce patient risks associated with exposure to potentially non‑sterile devices or inadequate sterilization procedures,
inspect the display screen and cycle reports for error codes and listen for audible notifications (if enabled). Always take action for error codes as indicated in this manual.
1. SelectCycle
The 3M™Steri‑Vac™ Sterilizer/Aerator GSX Series has two validated preprogrammed cycle options: GSX 38C (100.4°F) and GSX 55C (131.0°F). Select the appropriatecycle.
Sterilizer
22.2
˚
C
98.0
kPa
Open door
Menu
Menu
04/20/2015
05:19:51
65432
1
7
Select cycle:
GSX 38C
GSX 55C
Figure64.
Step One: SelectCycle