Loosen
Tighten
2.3.1 Non-drive-side powermeters
To replace the battery on your non-drive-side powermeter, you will need a new
CR2032 coin lithium ion battery.
2
GETTING STARTED
1. Do not pry your battery cap.
To remove, twist the battery
cap counterclockwise on
your powermeter
2. Remove the old battery from
the battery cap. To remove
the battery from the cap,
hold the cap by its edges
and tap it against a hard
surface
3. Place your battery into the
cap with ‘+’ facing the white
sticker inside the battery cap
Quick Tip: Do not remove the
white sticker inside the battery
cap, it holds the metal contacts.
5
Table of Contents
To Next Page
Loading...
Need help?
General
