GLUCOFIX
®
TECH - 51415 - 02/20
UK
33
Your meter uses two CR2032 3V lithium batteries. This type of battery is available in many stores.
Keep spare batteries handy at all times.
You do not need to set the date and time if you insert new batteries within 2 minutes after removing
the old ones.
If batteries replacement takes longer than 2 minutes, the meter will automatically require to reset
Date and Time before any operation (see 6.1).
Replace the batteries as follows:
a. Make sure the meter is switched o.
b. Remove the battery cover at the rear of the meter.
c. Remove the batteries.
d. Fit the new batteries into the battery holder with the “+” pole facing upwards.
e. Close the battery holder.
WARNING
● If the batteries are inserted upside down, the meter will not operate.
● The meter clock may stop if you touch the metal parts inside the meter with your
hands or metal.
● If you replace batteries after 2 minutes and do not set the time, all subsequent test
results will be stored with the incorrect date and time.
● Dispose of old batteries according to local environmental regulations.
7. METER CARE
To Next Page
Loading...
