12-8. (A). Pump control ON/OFF Conditions (Only for single and Easy-link system)
To run circulation pumps efficiently and effectively, the T-H2-DV/T-H2-OS offers four different modes of
pump control. The following table shows the pump control ON/OFF conditions for different modes. To
change pump control modes, see section 12-5 for dipswitch settings.
“Normal mode” and “Storage tank circulation mode”
There are no specific ON/OFF conditions for these two modes. The circulation pump will receive a
constant “ON” signal from the pump terminal on the computer board, and will run continuously.
“Re-circulation mode” and “Energy conserving re-circulation mode”
These functions enable the re-circulation pump to be controlled by the following conditions.
ON/OFF Conditions Re-circulation mode Energy conserving re-circulation mode
Conditions that activate
the pump
The BTU requirement is more than
14,880 BTU/h*
OR
30 minutes have elapsed after
previous operation
Inlet water temperature is less than
95°F(35°C) and flow rate is less than
0.8GPM
OR
20 minutes have elapsed after previous
operation
Conditions that
deactivate the pump
5 minutes after activation, if the
computer detects a BTU
requirement of less than 14,880
BTU/h, the computer will stop the
pump in 90 seconds.
1 minute after activation, if the
computer detects a BTU requirement of
less than 14,880 BTU/h, the computer
will stop the pump in 75 seconds.
*The computer records the inlet temperature and the flow rate of the pump during the final minute of
its previous operation when calculating the BTU requirement.
To Next Page
Loading...
Need help?
General
