What to do if the A&D Remote Control bar display remains and the weight value is not displayed?
If the bar display remains and the weight value isn't showing on your A&D Remote Control, verify that the weighing instrument's data output mode is set to 'stream mode'. Also, confirm that the communication settings are accurate and the cables are the right type and undamaged.
Why is the A&D Remote Control display flickering?
Display flickering on the A&D Remote Control may be due to electrical noise. Grounding the FG terminal on the back of the AD-8923-BCD may resolve this issue.
How to fix A&D Remote Control communication settings mismatch?
If the communication settings of the AD-8923-BCD don't match those of the weighing instrument, check settings like baud rate and parity and correct them as needed.
Why does error 10 appear on my A&D Remote Control?
Error 10 on your A&D Remote Control indicates a mismatch in communication settings between the AD-8923-BCD and the weighing instrument. To resolve this, check settings like baud rate and parity, and correct them as needed.
How to fix display flickering on A&D AD-8923-BCD Remote Control?
Display flickering on the A&D Remote Control may be due to electrical noise. Try grounding the FG terminal located on the rear of the AD-8923-BCD to resolve this issue.
General| Brand | A&D |
|---|---|
| Model | AD-8923-BCD |
| Category | Remote Control |
| Language | English |
To Next Page