15
Desired Sample Size Not Using The SAMPLE Key
1. The three UNIT WEIGHT BY LED’s should be blinking at this
point, if not, press the RESET key to clear any unit weight. If
you are going to use a tare container, place it on the weighing
pan and press the TARE key. Be sure the weight display is “0”.
2. Place sample pieces on the
weighing pan (or in the tare
container).
The weight of the pieces will be
displayed.
3. Use the 0 Æ 9 10-key pad to
enter the sample size of the pieces
you placed.
If you hit the wrong key, press
the C key to clear and enter
again. (Example of setting a sample
size of 20)
4. Press the ENTER key.
The display will show “-------” for a
moment while calculating the unit
weight. After a moment the display
will show the count, total weight and
unit weight.
If the “add ##” display appears on the
unit weight display, then the sample
size is not large enough for accurate
counting – add the additional number
of sample pieces.
5. You may now begin counting
operations for pieces of the same
weight.
888.8.8.810
COUN
To Next Page
Loading...
