30
9. F-FUNCTION PARAMETERS
9-1. To Change or View F-Function Settings
Start with the scale switched off.
1. Press and hold the ZERO key, then press
the ON/OFF key.
The count display will show “f-00” with
“00” blinking. Then release both keys.
2. Press the 0 Æ 9 keys to
display the number of the F-
Function section.
For example: the 5 key to enter into the
F-Function F-05-X Comparator section.
3. Press the ENTER key.
The count display will show the F-
Function and its present setting will
blink.
4. You may now either change the setting (Step
5) or move to the next F-Function (Step 6).
5. Use the 0 Æ 9 keys to change
the setting.
The
C key clears the input setting if you
press the wrong key and want to re-enter.
If you make a mistake and want to escape without saving any changes made after
the last time the
ENTER key was pressed – press the ON/OFF key to exit.
6. Press the ENTER key to save
any changes and/or move to the
next function.
7. When finished: press the ON/OFF key
to exit. Then, press it to turn the display
back ON. New settings will operate as
set.
ON
OFF
ZERO
+
8f-00810
8f-05810
8f-05-01
8
8Clear
8
8
aidal00
To Next Page
Loading...
