A&D SV-1A - 13 Command List (for All Models)

80
13. COMMAND LIST (FOR ALL MODELS)
The viscometer can be controlled by the following commands from the computer.
Add a terminator
( 0Dh、0Ah ) to each command.
Command Description
Q Outputs the current data.
SIR Outputs data continuously
C Stops data output by SIR command.
QM Outputs the data during measurement. (Effective only during measurement.)
START
Same as the START key
STOP
Same as the STOP key
HOLD
Same as the HOLD key
MODE
Same as the MODE key
PRINT
Same as the PRINT key