ENGLISH 7
Measurement
1. Place the cuff on the arm (preferably the left arm).
2. Press the
START button.
When the START button is pressed, all of the
display symbols will display for about one second.
When the " 0 " is flashing, the device is ready for
measurement. If the
mark is displayed, the cuff
has some air trapped in it. Press the exhaust
valve button until the
mark is displayed.
3. Pressurize the cuff by squeezing the rubber bulb.
The figure on the left of the
display shows the current
pressure as you inflate the cuff.
Stop squeezing the rubber bulb
when the
mark disappears.
4. When pressurization is completed,
the automatic exhaust mechanism
will gradually reduce the pressure
in the cuff and the
mark will
display along with the current
pressure reading on the left.
Remain still during the
measurement. When a pulse is
detected, the
mark will flash
in unison with the pulse of the
person being monitored.
5. When the measurement is
complete, the
mark is displayed.
The systolic pressure is displayed
on the left. The diastolic is
displayed on the right. The pulse
rate alternates with the systolic and
diastolic displays.
START button
Stop squeezing the bulb
when the
mark
disappears.
Detecting the pluse,
the mark is flashed.
Flashing
Systolic pressure
Diastolic pressure
To Next Page
Loading...
