How to troubleshoot no power on A&S Hurricane-S?
If your A&S Speakers have no power, first ensure the AC cord is properly connected. Next, check if there is power at the AC outlet. Finally, press the standby button to turn the unit on.
What to do if A&S Hurricane-S Speakers have no response?
If your A&S Speakers are not responding, disconnect and reconnect the AC power plug, and then turn the unit on again.
Why is the remote control not working on my A&S Speakers?
If the remote control isn't working with your A&S Speakers, try these steps: * First, select the correct source before pressing any playback control button. * Reduce the distance between the remote and the unit. * Ensure the battery is inserted with correct polarities (+/-). * Replace the battery. * Aim the remote directly at the sensor on the front of the unit.
Why does the clock setting keep getting erased on my A&S Speakers?
If the clock setting on your A&S Speakers is erased, it's likely due to a power interruption or the power cord being disconnected. Reset the clock to resolve this.
What to do if the disc does not play on A&S Speakers?
If your A&S Speakers disc does not play, ensure the disc is inserted correctly with the label side facing up. Clean the disc. Also, check if PAUSE mode is activated and deactivate it. If condensation has formed inside the unit due to a sudden change in temperature, wait about an hour for it to clear and try again. Note that if a non-valid disc has been inserted, the unit will not play it.
What causes poor radio reception on A&S Hurricane-S Speakers?
If you are experiencing poor radio reception with your A&S Speakers, increase the distance between the unit and your TV and VCR.
Why do A&S Hurricane-S Speakers power off after 15 minutes?
If your A&S Speakers are powering off after 15 minutes, and the unit’s external input signal level is too low, increase the volume level of your external device.
To Next Page
General