14
Troubleshooting
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using
this unit, check the following points before requesting service.
No power
- Ensure that the AC cord of the apparatus is properly connected .
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any playback control button, rst select the correct source.
- Reduce the distance between the remote control and the unit.
- Insert the battery with its polarities (+/-) aligned as indicated.
- Replace the battery.
- Aim the remote control directly at the sensor on the front of the unit.
I can't find the Bluetooth name of this unit on my Bluetooth device
- Ensure the Bluetooth function is activated on your Bluetooth device.
- Re-pair the unit with your Bluetooth device.
Poor radio reception
- Increase the distance between the unit and your TV and VCR.
Clock setting erased
- Power has been interrupted or the power cord has been disconnected.
- Reset the clock.
No Response From the Unit
- Disconnect and reconnect the AC power plug, then turn on the unit again.
The disc does not play
- There is no disc inside the unit (“NO DISC” appears on the display).
- Insert the disc correctly with the label side facing up.
- Clean the disc.
- PAUSE mode may be activated, deactivate it.
- A non-valid disc has been inserted.
- Condensation may have formed inside the unit due to a sudden change in temperature. Wait about
an hour for it to clear and try again.
This is a 15 mins power off function, one of the ERPII standard requirement for
saving power
- When the unit’s external input signal level is too low, the unit will be turned o automatically in 15
minutes. Please increase the volume level of your external device.
To Next Page