EasyManua.ls Logo

AAON R90800 - Module Overview

AAON R90800
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Guide 3
Full Digital Module
Overview
The Full Digital Module (OE370-23-FD-A) is a device that enables and
modulates up to four digital compressors on HVAC Units controlled
by the VCM-X Modular Controller (OE332-23-VCMX-MOD-A) or
VCM-X Modular E-BUS Controller (OE332-23E-VCMX-MOD-A).
The Full Digital Module will control the digital compressors to satisfy
the cooling, dehumidi cation, and heat pump requirements of the VCM-
X Modular series controller.
If the Full Digital Module is in the Cooling Mode or Heat Pump Heat-
ing Mode, it will modulate the compressors to maintain the appropriate
Supply Air Temperature Setpoint. If the module is in the Dehumidi ca-
tion Mode, it will modulate compressors to maintain the Coil Suction
Temperature Setpoint. If the module is in the Heat Pump Heating Mode,
the module can also monitor a signal for a Defrost Cycle from the VCM-
X Modular series controller if a One Condenser Head Pressure Module
(OE370-23-HP1C) is also installed.
Module Overview
Figure 1: Full Digital Module
The Full Digital Module is connected to the VCM-X Modular Control-
ler using the E-BUS Distribution Module (OE365-23-EBD). The Full
Digital Module can also be directly connected to the VCM-X Modular
E-BUS Controller. Either connection allows the Full Digital Module
to receive setpoints and monitor the Supply Air Temperature from the
VCM-X Modular series controller. The Full Digital Module requires a
24 VAC power connection with an appropriate VA rating.
NOTE: The Full Digital Module contains no user-serviceable
parts. Contact qualified technical personnel if your
module is not operating correctly.
www.orioncontrols.com
1003
1002
10uF
300
1
2
4
8
SERIAL #
C2
D3
D4
R7
R9
R11
R12
R13
R14
R23
R24
R25
R26
R28
R29
R30
SW1
D12
D13
R53
R54
TB3
C20
R34 R50
SW2
+5V
SIG 2
GND
1003
1002
10uF
1003
1002
10uF
1003
1002
10uF
4751
4751
4751
4751
OFF
OFF
OPTIONS
ALARM
ANALOG
STAT
+5V
COMM
GND
SIG 4
300
GND
BIN 2
R1
4
R2
4
GND
1002
1002
1002
1002
1002
1002
1002
1002
RELAYS
ADDRESS
SIG 3
+5V
GND
BIN 1
COM
+5V
SIG 1
R3
R4
Rc
AO1
AO2
PWM1-
PWM1+
PWM2-
PWM2+
.01uF
PWR

Related product manuals