VCC-X Operator Interface SD
MODULAR SERVICE TOOL SD
15
Holiday Start/Stop Times
VCC-X Schd ID #
Holiday Schedule
Start Event #1: XXXX
Stop Event #1: XXXX
VCC-X Schd ID #
Holiday Schedule
Start Event #2: XXXX
Stop Event #2: XXXX
The fourteen holidays all use the same Start and Stop times which
you program on this screen and the next. You must enter the time
in 24-hour military format, the same as a regular week schedule.
Normally, the holidays will operate in an unoccupied mode or a
reduced schedule mode. There are two start/stop events available on
holidays to match the standard schedule number of events.
Holiday Scheduling and Schedule Override
Schedule Override
VCC-X Ovrd ID #
Schedule Override
Enter Override: X
[0=Auto 1=ON 2=OFF]
If you want to force the unit to operate in a continuous Occupied
or Unoccupied mode, select this menu item to activate the desired
method. If a Schedule Override is active, all other methods of
schedule control are ignored (Push-Button, Internal, and Remote).
As you can see on the last line of the display,
enter <1> to run con-
tinuously in the Occupied Mode or <2> to run continuously in the
Unoccupied Mode. To restore normal schedule operations, enter <0>.
This override remains in effect until canceled and does not time-out
like the Output Overrides do after 10 minutes of no communications.
NOTE: Do not use the Force OFF mode in place of setting
all the week schedules to ZERO if you are using a
Remote Signal for your scheduling since the Override
has priority over the Remote Signal.
To Next Page
Loading...
Need help?
General
