Zone
Zone
SD CARD UPDATING INSTRUCTIONS
The Modular Service Tool and Modular System Manager are equipped with
an SD memory card. This SD card can be removed and easily updated
through a computer by downloading updates, as they become available,
from our website to your computer.
In order to perform any updates, your computer needs an SD card drive or
you will need to purchase an SD card adapter.
Download instructions are found in Appendix B on page 88 of this manual.
WattMaster Controls, Inc.
8500 NW River Park Drive · Parkville, MO 64152
Toll Free Phone: 866-918-1100
PH: (816) 505-1100 · FAX: (816) 505-1101
E-mail: mail@wattmaster.com
Visit our website at www.orioncontrols.com
WattMaster Form: AA-VCCXOISD-TGD-01E
Copyright March 2017 WattMaster Controls, Inc.
AAON Part Number: V57150
AAON
®
is a registered trademark of AAON, Inc., Tulsa, OK.
Neither WattMaster Controls, Inc. nor AAON
®
assumes any responsibility for errors or omissions in this
document.
This document is subject to change without notice.
www.aaon.com
IMPORTANT NOTICE
This technical guide provides instructions for using the Modular Service
Tool and Modular System Manager SD with the VCC-X & VAV/Zone
Controllers only. If you are using a different controller, you can download
the applicable SD Technical Guide listed below from our website—
orioncontrols.com. The technical guides can also be printed from the SD
card.
VCB-X Controller - AA-VCBXIOSD-TGD
VCM-X & VCM-X E-BUS Controller - AA-VCMXRNEOISD-TGD
RNE Controller - AA-VCMXRNEOISD-TGD
SA E-BUS Controller - AA-SAOISD-TGD
VCM Controller - AA-VCMOISD-TGD
VAV/CAV and MUA II Controllers - AA-VAVCAVMUAOISD-TGD
To Next Page
Loading...
Need help?
General
