TR-069 Protocol Support
12 41-001373-01 REV02 – 05.2014
Factory Reset
The purpose of a factory reset is to restore the configuration to default when it is requested by the ACS server. From the
ACS server, make a “factory reset” request. This will set all the parameters to the default value.
Device Data Model Support
For this release, the phones support only the configuration parameters listed in the section, “TR-069 Functionality Sup-
port” on page 2, for remote management through the TR-069 Protocol. Some ACS’s (e.g. a specific home management
device) requires a vendor-specific device data model in XML format before the IP phones can connect to it. See “Appen-
dix B - XML Data Model” on pageB-1 for an example of an XML data model.
As defined in this data structure, some parameters have write privileges and can be changed remotely (e.g. DNSServer).
However, you may have to reboot the phone in order for the change to take effect.
OUI and Product Class
The above data structure is common across all the TR-069 supported Aastra SIP phones. The table below summarizes the
supported phones and their corresponding OUI and Product Class.
Note:
A factory reset will result in the phone clearing out all configured parameters, including the TR-069 configured settings.
Supported Aastra Models OUI Product Class
6730i 00085D 6730i
6731i 00085D 6731i
6735i 00085D 6735i
6737i 00085D 6737i
6739i 00085D 6739i
6753i 00085D 6753i
6755i 00085D 6755i
6757i 00085D 6757i
6863i 00085D 6863i
6865i 00085D 6865i
6867i 00085D 6867i
9143i 00085D 9143i
9480i 00085D 9480i
To Next Page
Loading...
