Team Functions
98
MenuCard “Prog. team key”
gLong press the team key, then select …
1 Modify text: The text currently assigned to the key is shown on the display of your
telephone. To change the text, press
O. Delete the existing text with the C
key and enter new text, if required. Press
O and confirm this with Save. If you
delete the text, only the key’s call number will be displayed.
2 Call signalling: Specify whether call signalling to this key is to be
Optical & acoustic, Optical only or Acoustic after delay. If you select Acoustic after
delay, specify the number of seconds after which your telephone is to ring.
3 Call protect: Switch call protection On or Off for all calls, for internal calls only, or for
external calls only. If call protection has been activated, this team key will only
indicate calls by means of a visual signal, even if they are made from a direct-call key.
4 Ring tone: You can set the Volume and Melody for different types of incoming calls
(1 External calls, 2 Internal calls, 3 VIP call, 4 Door call) for each team key. Proceed
as described in the section “2 Ring Tone” on page 113.
5 Call wait. prot.: While you are making a call, other calls for the call number of this
team key are not signalled by a call waiting tone (but at the team keys of other ter-
minals unless call waiting protection was programmed there). Use the On / Off
options to switch the call waiting protection function on or off.
6Lists: Define if for the call number of this team key the caller lists (missed calls and
accepted calls) and the redial list are recorded. Use On/Off to activate/deactivate the
lists for this team key.
Direct-call Key
When a direct-call key is long pressed, no MenuCard is displayed. A direct-call key is
configured exclusively via the Configurator of the OpenCom 100 / Aastra 800 Web
console.
To Next Page
Loading...
