Remote-Controlled Functions
100
You can call the OpenCom 100 / Aastra 800 from an external telephone, from your
home for example, and then dial an external call number. The cost of the call is then
billed to the OpenCom 100 / Aastra 800 line. This way you can take advantage of dif-
ferent tariff zones, for example.
For this feature, the system administrator must have set up a call number (for remote
control) in the OpenCom 100 / Aastra 800. In addition, the number reserved in the
OpenCom 100 / Aastra 800 can also be assigned an internal call number via which the
dialling is to be performed. In the case of remote-controlled dialling, there is no check
on authorisation.
Least Cost Routing (LCR) is used with remote dialling, provided the system adminis-
trator has correspondingly configured LCR and its application in the OpenCom 100 /
Aastra 800. Ask your administrator for the configuration applicable to you.
Remote-Programmable Call Forwarding
Configuring the Function
Z Enter the external call number.
* Press the star key.
Z Enter the internal call number.
# Press the hash key.
Z Enter the reserved call number.
Z Enter the system PIN.
* Press the star key.
Z Enter your internal call number.
* Press the star key.
Z Enter the trunk line seizure code, e. g. 0.
Z Enter the destination call number.
# Press the hash key.
To Next Page
Loading...
