Telephoning
75
• Announcement without intercom: The called subscriber hears a special infor-
mation tone followed by your announcement. In order to answer your
announcement, the subscriber has to take the call just like a normal call (please
refer to the section Responding to an Announcement on page 76 also).
If you make an announcement to a group of system telephones (e. g. to a hunt
group number on which calls are signalled simultaneously), all subscribers called
hear the announcement at the same time. You hear a signal tone via your tele-
phone when the (announcement) connection has been made to all called sub-
scribers. If one of these subscribers replies to the announcement (by accepting the
call), the announcement call to the other system terminals is terminated.
If a subscriber being called has activated announcement protection or intercom pro-
tection, announcements to that subscriber’s call number will not be carried out.
Making an Announcement without Intercom
Making an Announcement with Intercom
M Briefly press the MenuCard key and
P Select
Announcement
.
Z Under
Dest.:
you enter the call number (of a single terminal or
of a group of terminals).
Make your announcement.
M Briefly press the MenuCard key and
P Select
Intercom
.
Z Under
Device-ID:
you enter the device-ID of the terminal. Your
system administrator can provide you with the device ID.
Make your announcement.
To Next Page
Loading...
