Installation and Setup
41-001505-00 REV00 – 04.2014 8
Installation
Desk Installation
For desk installation of the 6863i IP Phone a reversible stand is included that attaches to the back of the phone above the
various ports. Two viewing angles (35° low angle and 55° high angle) are available allowing users to personalize their
phone viewing preference.
1. Locate the stand insertion area on the back of the phone (above the various ports).
2. Carefully insert the stand into the insertion area and slide the stand towards the right until it snaps in place.
Note:
The orientation of the stand determines the viewing angle. If the bottom of the stand is installed facing the top of the
phone the viewing angle will be 35
°. If the bottom of the stand is installed facing the bottom of the phone the view-
ing angle will be 55
°.
To Next Page
Loading...
