Installation and Setup
41-001505-00 REV00 – 04.2014 10
4. Using your index finger and thumb, rotate the handset hook 180° as illustrated in the figure below.
The handset hook is now in the correct position ensuring that your phone’s handset securely stays on hook when
the phone is mounted to the wall.
5. Using the provided screws, attach the Wall Mount Base to the wall ensuring the Vertical Screw Lock Hole is facing up.
Note:
Depending on the wall type, you may need to use wall anchors. Two wall anchors are included with your 6863i IP
Phone
.
6. On the back of your phone, connect the provided Ethernet cable into the network port marked with . Plug the
other end of the Ethernet cable directly into the network jack on the wall.
To Next Page
Loading...
