Aastra 7433ip - Adding Contacts

6/1553-DBC 433 01 Uen B6 2010-07-09 62
C
ONTACTS
8.3 Adding a Contact
There are three ways to add a contact:
• Manually add a new contact.
• Add a number from the call list.
• Add contact from the web interface, see 14.3.1 Contacts Folder on
page 94.
8.3.1 Adding a New Contact
To add a new contact, do the following:
1. Press .
2. Press more....
3. Select Add new manual input, and press Select.
4. Enter a number, and press OK.
If you make a typing mistake, press the volume down key or more...
and select Erase or Erase all.
5. The new contact is added, with the number saved also as name.
Note: If you would like to edit the name, number or ring signal
for this contact, press more..., and select what to edit. See 8.4
Editing a Contact on page 63 for more information.
6. Press Done to save the new contact.
Note: Numbers beginning with 0 are preceded by the digit or
digits required to reach an external line. The digits can also be
stored by adding the country code number after a plus sign, for
example +46 8 719 0000.
8.3.2 Adding a Contact From the Call List
To add a contact from the call list, do the following:
1. Press .
2. Press more....
3. Select Add new from Call List, and press Select.
4. Select the number to add as a contact, and press Add.
5. Note: If you would like to edit the name, number or ring signal for
this contact, press more..., and select what to edit. See 8.4 Editing
a Contact on page 63 for more information.