Voice over IP (VoIP)
108
5. On the Telephony: Trunks: SIP Trunks page, click on New. Activate the Status
and enter a name for the account under Name. Select the SIP Provider. Enter the
relevant account information under User name, Password, Phone No. and SIP ID.
Click on Apply.
The SIP ID setting will be used while logging in to the SIP provider. Die Phone No.
setting denotes the external phone number used within the public phone
network. You can enter this number here to support system administration.
6. Call up the Telephony: Trunks: Route: New page once again. Enter “SIP”, for
example, under Name, under Code the number “8” and select the SIP account that
was just configured for Bundle/SIP trunks 1. The SIP account is now available
with the dialling prefix “8”. To use the SIP account by default, call up the page
Telephony: Trunks: Route and select the route External trunk. Under Bundle/
SIP trunks 1, select the SIP account you have just set up. Click on Apply.
Note
The Telephony: Trunks menu page is only displayed if you activate the Level: Ex-
pert option on the opening page of the Configurator.
7. Check that the SIP connection is active on the System Info: Telephony: Trunks
page. Also check the SIP licence count on the System: Licences page.
Check the functionality by making an external call. You should assign the relevant
external number of the SIP account to the internal numbers on the page Telephony:
Call distribution: Incoming.
To Next Page
Loading...
Need help?
General
