Configuration
85
Note
You can download the latest version of the online help from http://www.aastra.de or
http://www.aastra.com.
Finishing the Configuration
1. When you have completed all the settings in the Configurator, you must save the
configuration (see also Saving and Loading the Configuration on page 85).
2. Then select the Log-off command in the upper menu bar.
Saving and Loading the Configuration
Configurations are saved in a file archive and can be loaded to the OpenCom 100
either locally from a connected configuration PC, or by remote configuration. The fol-
lowing configuration and customer data can be saved and loaded again:
• Telephony and network parameters
• User data
• Telephone book entries
• LCR tables
Note, that for security considerations the passwords for external SIP trunks are not re-
established if you restore a data backup from another (foreign) communication
system. For further information, refer to the online help documentation under the
topic System: Data backup.
Preconfiguration
Configuration of the OpenCom 100 can be prepared at your Aastra Customer Service
Centre or by an authorised Aastra dealer. For this purpose, a OpenCom 100 installed
here is programmed with the customer data (e.g. user data, call distribution schemes,
cord-bound terminals). This data is stored and then loaded into the OpenCom 100 at
the customer’s site by a service technician.
This prepared configuration must be completed at the customer’s site (LAN configu-
ration and DECT terminals).
For configuration of the OpenCom 100 Internet functions, first ask the responsible
system administrator for details of the customer’s LAN prerequisites.
To Next Page
Loading...
Need help?
General
