29. Application Packages
29.1 Base App
Base application package is always included in SSC600 and
contains following functions instances. Amount of circuit breaker
control functions and SMV receiver functions depends on the Digit
9 selection.
Table 114. Protection functions
Function Name IEC 61850 Name Number of Instances
Three-phase non-directional overcurrent
protection, low stage
PHLPTOC 40
Three-phase non-directional overcurrent
protection, high stage
PHHPTOC 20
Three-phase non-directional overcurrent
protection, instantaneous stage
PHIPTOC 20
Non-directional earth-fault protection, low
stage
EFLPTOC 40
Non-directional earth-fault protection, high
stage
EFHPTOC 20
Non-directional earth-fault protection,
instantaneous stage
EFIPTOC 20
Negative-sequence overcurrent protection NSPTOC 40
Residual overvoltage protection ROVPTOV 8
Three-phase undervoltage protection for 10
feeders (across 4 bus sections)
PHPTUV 40
Three-phase overvoltage protection for 10
feeders (across 4 bus sections)
PHPTOV 8
Positive-sequence undervoltage protection
for 10 feeders (across 4 bus sections)
PSPTUV 40
Negative-sequence overvoltage protection
for 10 feeders (across 4 bus sections)
NSPTOV 8
Frequency protection for 4 bus sections FRPFRQ 16
High impedance based restricted earth-
fault protection
HREFPDIF 20
Circuit breaker failure protection CCBRBRF 20
Three-phase inrush detector INRPHAR 20
Switch onto fault CBPSOF 20
Master trip TRPPTRC 40
Multipurpose analog protection MAPGAPC 40
Table 115. Control
Function Name IEC 61850 Name Number of Instances
Circuit-breaker control CBXCBR 5...20
Disconnector control DCXSWI 40
Earthing switch control ESXSWI 20
Disconnector position indication DCSXSWI 60
Earthing switch position indication ESSXSWI 40
Table 116. Condition Monitoring
Function Name IEC 61850 Name Number of Instances
Circuit-breaker condition monitoring SSCBR 20
To Next Page
Loading...
