Insertion of the TA 951F battery Section 7 Commissioning
96 M&I – AC 900F Controller
Module with battery holder
Place the battery in inclined position onto the lower holder. Press the
battery downwards and then to the left until it locks in the upper holder.
Both holders are provided for locking purposes only; they are not
electrically connected to the battery.
To connect the battery to the power supply, plug in the battery connector into the
mating socket. The connector is keyed to ensure reverse polarity protection. Close
the housing with the previously removed front panel or display unit.
Battery_04_us.png
To Next Page
Loading...
