ABB AC500-eCo Series - 3.1.2 Wall Mounting

________________________________________________________________________________________________________
AC500-eCo - 16 - Hardware Introduction
3.1.2 Wall Mounting
If the CPU or I/O module should be mounted with screws, Wall Mounting Accessories TA566
must be inserted at the rear side first.
1. The Wall Mounting Accessories TA566 is snapped on the rear side of the CPU or the I/O
modules.
Figure 8 Wall mounting of the hardware
2. CPU or I/Os fastened with screws. Use two screws per module. Use M4 or #8 pan head
screws. Mounting screws are required on every module.
Figure 9 Fastening with screws of the CPU and I/O Modules