ACH550 E-Clipse Bypass User’s Manual 2-71
Parameters
1624 ST EN4 TXT 1 0 = START ENABLE 4
...
START
ENABLE
4
(0)
Alternative text choices for alarm
4024.
See parameter 1621 for range.
1625 COMM CTRL 1 0 = DRIVE ONLY
1 = SYSTEM
DRIVE
ONLY
(0)
Selects comm control mode. In
drive only mode, control of drive
is made through drive points, and
control of bypass over comms is
not possible. In system mode,
control of system (bypass or
drive) is made through bypass
points.
1626 MODE LOCK 1 0 = NOT SEL
1 = AUTO MODE
2 = LOCAL MODE
NOT SEL
(0)
When Mode Lock is AUTO
MODE, the control panel will not
allow switching to Hand or Off.
When Mode Lock is LOCAL
MODE, the control panel will not
allow switching to Auto.
1627 COST/KWH 0.1 c/kWh 0.0 - 100.00 c/kWh 7.0 c/kWh Cost of energy: cents/kWh
1628 LEARN
MODE
10 = NOT SEL
1 = ENABLED
NOT SEL
(0)
When enabled, bypass learns
average power consumption
while operating in bypass mode
1629 LEARN TIME 0.1 Hr 0.0 - 200.0 Hr 48.0 Hr Time that learn mode will be
active after it is enabled
Group 16: System Control
Code Name Resolution Range Default Description
To Next Page
Loading...
