ABB ACS 300 Series - Page 2 Parameters

ACS 300 User’s Manual 49
Chapter 7 - Drive Parameters
PAGE 2 (* P3) Display only – – 54 Press to change to
page 3
201 OUTPUT V Display only – – 54 Output voltage to motor
202 CON f 1 0.0 – 200/500 Hz
1)
5.0 Hz 54 Preset speed 1
203 CON f 2 0.0 – 200/500 Hz
1)
25.0 Hz 54 Preset speed 2
204 CON f 3 0.0 – 200/500 Hz
1)
50.0 Hz 54 Preset speed 3
205 I LIMIT 0.5 – 1.5 x I
N
1.5 x I
N
55 Output current limit
206 START (0) Acc Ramp/Flying/
Auto Boost/
Fly+Boost
Acc Ramp 55 Starting mode selection
207 STOP (0) Coasting/Dec Ramp/
DC Brake/Dec+Brake/
Dec+Hold
Coasting 56 Stopping mode selection
208 RAMP (0) Linear/Fast S/
Medium S/Slow S
Linear 56 Acceleration/deceleration
ramp shape selection
209 REF OFFSET (0) 0V 0mA/2V 4mA/
Joystk/Custom
0 V 0 mA 57 Analogue input minimum and
type selection
210 A. OUT None/Out Freq/Ref
Freq/Motor Curr
None 60 Analogue output function
selection
211 A. OUT OFFS 0 mA/4 mA 0 mA 61 Analogue output minimum
212 SWITCH f 1.0 – 16.0 kHz 4 kHz 61 Switching frequency
213 CRIT f1L 0.0 – 200/500 Hz
1)
0.0 Hz 61 Critical frequency 1 start
214 CRIT f1H 0.0 – 200/500 Hz
1)
0.0 Hz 61 Critical frequency 1 end
215 CRIT f2L 0.0 – 200/500 Hz
1)
0.0 Hz 61 Critical frequency 2 start
216 CRIT f2H 0.0 – 200/500 Hz
1)
0.0 Hz 61 Critical frequency 2 end
217 IR-COMP Off/0.1 – 60 V/ Auto Off 63 Low speed torque boost value
218 DC BRAKE 0 – 250 s 3 s 65 Duration of DC braking/DCHold
219 U/f RATIO (0) Linear/Square/Optim Linear 65 Voltage to frequency ratio
220 RESTART # Off/1 – 10/Cont Off 66 Nr. of start attempts after fault
221 TEMP LIM Off/1 to 500 Hz Off 66 Motor thermal protection
222 MOTOR I 0.5 to 1.5* I
N
I
N
67 I
NMOT
for thermal protection
223 DIR. FWD/REV; FWD only FWD/REV 67 Reverse lock-out
224 AI-FAULT Enable/Disable Enable 67 AI fault if AI< 2 V/ 4mA
Code Parameter Range Default
Cus
tomer
Page Description