24
Resetting the Drive from the Control Panel
When the red LED of the ACS140 is on or blinking, a fault is active.
To reset a fault when the red LED is on, press the START/STOP button.
Caution! This may start the drive, when in remote control.
To reset a fault when the red LED is blinking, turn the power off.
Caution! Turning the power on again may start the drive immediately.
The relevant fault code (see Diagnostics) flashes in the panel display until the
fault is reset or the display is “cleared”.
You can “clear” the display without resetting the fault by pressing any button.
The word FAULT will be displayed.
Note! If no other button is pressed within 15 seconds and the fault is still
active, the fault code will be displayed again.
After a power failure, the drive will revert to the same control mode (LOC or
REM) as before the power failure.
www.barghmaher.org
To Next Page
Loading...
