ABB ACS355 - Using Visualizations; Controlling the Drive with the Visualization

20 Customization
Using visualizations
The visualization of a project can be used to monitor states in the function blocks, and
errors and actual values. See the image below.
 Controlling the drive with the visualization
To use the visualization to control the drive,
disconnect all inputs of the function block to be
controlled with the visualization in the program.
For example, to control START, STOP_COAST,
RESET and SPEED_REF through the visualization,
disconnect them from the FB_BASIC_CONTROL
function block.
Once disconnected, you can set the input values
directly in the visualization element. In this example, START, STOP_COAST, RESET and
SPEED_REF can be set through the visualization.