Instruction IN/RandC/003–EN Rev.A
ControlMaster controllers and indicators
ConfigPilot
Creating, uploading and downloading configurations
Measurement made easy
1Introduction
A configuration for a ControlMaster (both controller and
indicator) can be created, modified and backed up to a
PC using the ConfigPilot software program.
ConfigPilot is a utility used in conjunction with a USB
IrDA adaptor and can be downloaded from:
www.abb.com/recorders.
2Items required
2.1 ConfigPilot kit
3 Firmware revision
The following instrument firmware revisions are compatible with
ConfigPilot:
Description Part no.
USB IrDA adaptor B12895
This publication IN/RandC/003-EN
Table 2.1 ConfigPilot kit CM30/0715
Instrument Firmware revision
CM15
CM15|P2|00|02|22
CM15|P2|01|02|22
or later
CM10
CM10|P2|00|02|22
CM10|P2|01|02|22
or later
CM30 CM30|P2|00|02|22 or later
CM50 CM50|P2|00|02|22 or later
CMF160 CMF160|P2|00|02|22 or later
CMF310 CMF310|P2|00|02|22 or later
Table 3.1 Instrument firmware revisions
IMPORTANT (NOTE) If using an earlier firmware
revision, contact your local ABB representative for more
information.
To Next Page
Need help?
General
