ABB DATUM L160 - Page 17

15
O.AdJ
1.0
SPGrAV
1.000
H150.2
rSt-n
•1
L130.8
rSt-n
•1
3 SET UP MODE…
…3.2 Setup Level (Level 2)
Maximum Value
This is the maximum value of the level input since the
maximum was reset.
o reset the maximum value, select rSt-Y then press
the
key.
rSt-Y – reset
rSt-n – do not reset
Minimum Value
This is the minimum value of the level input since the
minimum was reset.
To reset the minimum value, select rSt-Y then press
the
key.
rSt-Y – reset
rSt-n – do not reset
Specific Gravity
Enter the specific gravity of the liquid to be
measured.
Offset Adjustment
An offset can be applied to the level input to enable spot
calibration or the removal of system errors.
[±10% of engineering range].
•1 The maximum and minimum values are reset automatically on power-up and
can also be reset from a digital input – see Section 4.3.3.
8