II F 2-15
3ADW000072R0501_DCS600_System_description_e_e
Drive control
Components required:
• Plastic optical fibre for distances up to 15 m.
• Field bus module Nxxx-xx
• FCI (CI810)
• AC80 (PM825)
• AC800 M
Functionality:
Depends on the used module, interface e.g. to:
• PROFIBUS with NPBA-12
• MODBUS with NMBA-01
• AF100 with FCI (CI810)
• AC80 (PM825) or
• AC800 M
• further modules on request
You will find more detailed information on data ex-
change in the specific PLC or fieldbus module docu-
mentation.
Operation by PC
Components required:
• Plastic optical fibre for distances up to 20 m.
• Network up to 200 drives (same as for ACS 600).
• HCS optical fibre cable up to 200 m.
See separate manual Configuration Instructions
NDBU 85/95; Doc no.: 3ADW000100.
Functionality:
• DriveWindow software package➀ for commission-
ing, diagnosis, maintenance and trouble shooting;
structure of connections see Technical Data; Doc
no.: 3ADW000165.
System requirements/recommendation:
• PC (IBM-compatible) with 486 processor or higher
(min. 50 MHz).
• 8 MB RAM.
• DOS version 5.0 or later.
• Windows NT4.0, WIN 2000, WIN XP
• VGA monitor.
• CD-ROM drive.
• PCMCIA slot or PCI/PCMCIA bridge.
In addition to the options provided by the CDP 312
control and display panel, there are further functions
available, and these are described on the following page.
➀ For further information see the specific publications
To Next Page
Loading...
Need help?
General
