2.12.2 Inspection, DressPack floor
General
In order to ensure adequate life of the equipment, it is vital that the cables and
hoses are properly installed and operated correctly, with their movement patterns
well within the acceptable limits.
This instruction details how to inspect the DressPack floor installation in this regard.
Procedure, process cable package
This section details each inspection to be carried out, not necessarily in any
particular order unless stated.
NoteAction
Make sure that the cable package is prop-
erly connected at the robot base as well as
at the other end.
1
Make sure that no hoses or cables, or parts
thereof, are routed in such a way that they
are subjected to wear, for example hoses
being run over by fork lifts etc.
2
Make sure that no cables or hoses rub
against any sharp corners which might
damage them.
3
Make sure all connection points are well
tightened and sealed in order to avoid leaks.
4
Product manual - DressPack/SpotPack IRB 6700 135
3HAC044270-001 Revision: F
© Copyright 2014-2017 ABB. All rights reserved.
2 Installation
2.12.2 Inspection, DressPack floor
To Next Page
Loading...
Need help?
General
