ABB Eden DYN - Mounting

2TLC172271M0201 Rev D 19
Mounting
Depending on the cable connector used for the connection to Eden, one or two distance plates
might be required for correct mounting in order to avoid damaging Adam. It is recommended to
use the distance plates DA 1B, supplied with the Adam, see figure below. Also, the mounting
spacers DA 2B supplied must be used in order to physically protect Eden from damage.
The cable must be mounted so that no force is applied on Adam in any directions. The cable must
be fixed if it is connected to a moving object, for example a cable chain or a door. This can be done,
with for example, two cable clamps.
Caution! An improperly installed cable can damage the sensor.
Mounting with one distance plate DA 1B for
Adam using prewired moulded M12
connector
Mounting with two distance plates DA 1B
for Adam using M12 connector with
glanded cable.
Incorrect mounting without distance plate
may cause permanent damage to the
sensor.
Accepted