EL3060 CONTINUOUS GAS ANALYZERS | OI/EL3060-EN REV. A 57
Start the communication between the gas analyzer and the computer
Communication between the configurator and the gas analyzer is started in
the menu "Options – Communication Properties…" or by clicking the symbol
. Input either the IP address or the network name (server name) of the
gas analyzer (see the following example of a point-to-point connection).
Receiving configuration data
After communication has been started, the configuration data can be re-
ceived from the gas analyzer.
Menu "File – Receive Data" or
.
Sending configuration data
After the configuration data been has edited, it can be sent to the gas ana-
lyzer. The configuration mode is active after an automatic cold restart of the
gas analyzer.
Menu "File – Send Data" or .
Saving configuration data
The configuration data of the gas analyzer can be stored in the computer.
The stored configuration file can be edited at a later date and sent to the
gas analyzer.
Menu "File – Save As…" or .
To Next Page
Loading...
