Need help?Do you have a question about the ABB EN Series and is the answer not in the manual?
General| Series | EN |
|---|---|
| Communication | Modbus, Profibus |
| Control Method | Closed-loop |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature |
| Cooling Method | Air |
Essential safety guidelines to follow during drive installation and operation.
Reform drive capacitors if the unit has been inactive for over a year.
Choose power cables sized according to local regulations and drive current.
Maintain drive within operating temperature range and prevent condensation.
Follow fuse recommendations for drive and input power cable protection.
Guidelines for safely mounting the drive on a wall, considering its weight.
Measure insulation resistance of power cables and motor before connection.
Check compatibility with IT or corner-grounded TN systems, regarding EMC filters.
Instructions for disconnecting internal EMC filters or ground-to-phase varistors.
Procedures for connecting input power and motor cables, including grounding.
Steps for routing and connecting signal cables to the control board.
Overview of default terminal assignments for the ABB standard macro.
Guidance on installing optional communication or I/O modules.
Steps to re-install side plates and covers after wiring.
Ensure drive installation is complete before proceeding with start-up.
Guide to using the control panel's First Start Assistant for initial configuration.
To Next Page
