4/21
1 General Information
1.1 Responsibility
The owner or provider is responsible for the proper use of the device. The installation, put-
ting into operation and reinstallation of the meter is only allowed to be done by electrically
skilled persons, which got knowledge about the contents of this user manual.
1.2 Common safety instructions
For installation, setting into operation and installation of the device the local requirements
for safety requirements must be observed.
Danger
Inappropriate use of parts under high voltage may lead to grave injuries and ac-
cidents, which may be fatal even with 230V.
The conductors which are connected to the device must be disconnected to the
mains during assembling and installation. It must be used a prevention for be-
ing switched on accidentally.
The device is not allowed to be used out of specifications.
1.3 Service and warranty instructions
Damaged devices can’t be repaired by you. The warranty and liability will be terminated with
opening the device. The same applies to damages caused by external influences.
For the device no servicing is required.
1.4 Disposal (product end of life information)
This meter was designed and built by ABB to provide many years of service and is backed by
our commitment to provide high quality support. When it eventually reaches the end of its
serviceable life, it should be disposed in accordance with local or national legislation.
To Next Page
Loading...
