6.2. MABS Control Card
Specifications are valid for cards in revision from
PRODUCT FAMILY: FSK II + - OPERATING AND MAINTENANCE MANUAL16 PRODUCT FAMILY: FSK II + - OPERATING AND MAINTENANCE MANUAL 16
1VSR630206EN – en – EDO-D0002852– Instruction manual – 2021.10 Design and specification are subject to change without notice
—
6. Technical Data
The used binary inputs can differ from
project to project. Please refer to the valid
wiring diagram.
These represent the range of
values the MABS card can accept.
The specific voltage used still
needs to be selected via Dip
switches as described later.
A detailed description of the control card is
provided in a separate operating manual
and is available on special request.
6.2.1. Supply Voltages
the MABS control card.
6.2.2. Power Consumption
6.2.4. Electrical Characteristics of the Signal Inputs
6.2.3. Binary Signal Inputs
Description Value Tolerance Frequency Insulation
Galvanic,
High Voltage Galvanic,
Table 1 Supply Voltage
Power Consumption [W]
Continuous in static mode (nominal)
Maximum during the capacitor charging operation
Designation Value
Voltage range
Tolerance
Input impedance
Input current
Table 4 Characteristics of the signal inputs
Designation Description Observation
Remote Close
Remote Open
independently of the state and condition of the CPU
Standard Open or Protective trip
LOCAL
REMOTE
GLOBAL
Lock in Open Locking of apparatus in the Open position
Under Voltage (Under voltage function)
Signal input for the detection of an undervoltage, variable
voltage values can be set
Table 3 Signal Inputs
To Next Page
Loading...
