GILLETTE ŁÓDŹ
Robotic station for packing FFS1 dispensers
When changing the control program, remember to clean the lines first -
especially the area under the grinders! If the conveyors in the grinder area are
not cleaned, changing the procedure from 4s to 8s may result in a collision and
damage to the grinders!!
Changing the control program
After stopping the process and retooling the device, the operator can start
changing the control program (4s or 8s).
Step 1: On the main screen, press the "Machine State Model" button
Figure 52 HMI main screen
ABB Sp. z o.o.
Side 95/135
DTR_GILLETTE_ZSDPD_Farmores1_IRB360_2015_v03
To Next Page
Loading...
