GILLETTE ŁÓDŹ
Robotic station for packing FFS1 dispensers
Step 2: Use the arrows to select the appropriate recipe and then confirm with
the ENTER button. After selecting the program, a graphic confirming the selected
recipe is displayed in the EM Operation window.
Figure 53 Selection of the control program in the Machine State Model window
ATTENTION!
When changing the control program, remember to clean the lines first -
especially the area under the grinders! If the conveyors in the grinder area are
not cleaned, changing the procedure from 4s to 8s will result in a collision and
damage to the grinders!!
ABB Sp. z o.o.
Side 96/135
DTR_GILLETTE_ZSDPD_Farmores1_IRB360_2015_v03
To Next Page
Loading...
