[270] Profibus DP Configuration Tool
Product Specification RobotWare Options for BaseWare OS 4.0 35
[270] Profibus DP Configuration Tool
The Profibus Configuration Tool is used to configure the master channel of the
Profibus DP DSQC 510 board. (See ‘I/O Interfaces’, in the S4Cplus Product
Specification.)
The tool consists of standard PC software. The tool creates a bus configuration, which
is used in the robot controller.
Note: This tool is NOT needed for configuration and use of other channels than the
master channel of the DSQC 510 board.
To Next Page
Loading...
