ABB IRB 6650 - 125/3.2 - Page 226

2 Reference information
2.1.5 Special tools
24 A 3HAC 16245-1
Note
a)
Calibration tools for IRB 6600/6650/7600 when CalPen is not used (standard).
Note
b)
Special tools that may be rent from ATRP/S.
Hydraulic pump 80Mpa (Glycerin) b b 3HAC 13086-2
Levelmeter 2000 kit a a 6369901-348
Lifting device, base 1 1 3HAC 15560-1
Lifting device, manipulator 1 1 3HAC 15607-1
Lifting device, upper arm 1 - 3HAC 15994-1
Lifting device, upper arm - 1 3HAC 15536-1
Lifting eye VLBG M12 1 1 3HAC 16131-1
Lifting eye M12 2 2 3HAC 14457-3
Lifting eye M16 2 2 3HAC 14457-4
Lifting tool (chain) 1 1 3HAC 15556-1
Lifting tool, gearbox ax 2 1 - 3HAC 13698-1
Lifting tool, gearbox ax 2 - 1 3HAC 12731-1
Lifting tool, lower arm b b 3HAC 14691-1
Lifting tool, motor ax 1, 4, 5 1 1 3HAC 14459-1
Lifting tool, motor ax 2, 3, 4 1 1 3HAC 15534-1
Lifting tool, wrist unit 1 - 3HAC 13605-1
Lifting tool, wrist unit - 1 3HAC 12734-1
Measuring pin a - 3HAC 13908-5
Mech stop ax 3 2 - 3HAC 12708-1
Mech stop ax 3 - 2 3HAC 12708-2
Press tool, ax 2 bearing 1 - 3HAC 13527-1
Press tool, ax 2 bearing - 1 3HAC 13453-1
Press tool, ax 2 shaft 1 1 3HAC 13452-1
Press tool, balancing device shaft 1 1 3HAC 17129-1
Press tool, balancing device 1 1 3HAC 15767-1
Puller tool, balancing device shaft 1 1 3HAC 12475-1
Removal tool, wheel unit - 1 3HAC 15814-1
Removal tool, motor M10x 2 2 3HAC 14972-1
Removal tool, motor M12x 2 2 3HAC 14631-1
Removal tool, motor M12x 2 2 3HAC 14973-1
Rotation tool 1 1 3HAC 17105-1
Sensor plate a 1 3HAC 0392-1
Support, base 1 1 3HAC 15535-1
Sync. adapter a a 3HAC 13908-1
Tool set balancing device 1 - 3HAC 15943-2
Tool set balancing device - 1 3HAC 15943-1
Turn disk fixture a a 3HAC 68080011-
GU
Washers for Mech stop axis 3 2 2 3HAA 1001-186
Description IRB 66X0/Qty IRB 7600/Qty Art. no.