ABB IRB 6650 - 125/3.2 - Page 225

2 Reference information
2.1.5 Special tools
3HAC 16245-1 A 23
2.1.5 Special tools
General All service (repairs, maintenance and installation) instructions contain lists of tools required
to perform the specified activity. The required tools are a sum of standard tools, defined in
section Standard toolkit on page 22, and of special tools, listed directly in the instructions and
also gathered in the table below.
Special tools, IRB
6600/6650/7600
The table below is an overview of all the special tools required when performing service
activities on the IRB 6600/6650/7600. The tools are gathered in two kits: Basic Toolkit
(3HAC 15571-3) and Extended Toolkit (3HAC 15571-2).
The special tools are also listed directly in the current instructions.
Description IRB 66X0/Qty IRB 7600/Qty Art. no.
Angel bracket a a 68080011-LP
Bolts (M16 x 60) for Mech stop ax 3 2 - 3HAB 3409-86
Bolts (M16 x 80) for Mech stop ax 3 - 2 3HAB 3409-89
Cal. tool a a 68080011-GM
Calibration bracket a - 3HAC 13908-9
Calibration tool ax1 a a 3HAC 13908-4
CalPen (Calibration Pendulum) 1 1 3HAC 15716-1
Extension 300mm for bits 1/2" 1 1 3HAC 12342-1
Fixture lower arm 1 - 3HAC 13659-1
Fixture lower arm - 1 3HAC 13660-1
Gearbox crank 1 - 3HAC 16488-1
Guide pins M12 x 150 2 - 3HAC 13056-2
Guide pins M12 x 200 2 - 3HAC 13056-3
Guide pins M12 x 250 1 - 3HAC 13056-4
Guide pins M8 x 100 2 - 3HAC 15520-1
Guide pins M8 x 150 2 - 3HAC 15520-2
Guide pins sealing - b 3HAC 14445-1
Guide pins sealing b - 3HAC 14446-1
Guide pins M10 x 100 2 2 3HAC 15521-1
Guide pins M10 x 150 2 2 3HAC 15521-2
Guide pins M16 x 150 - 2 3HAC 13120-2
Guide pins M16 x 200 - 2 3HAC 13120-3
Guide pins M16 x 250 - 1 3HAC 13120-4
Guide pins M16 x 300 2 2 3HAC 13120-5
Guide pins sealing ax 2, 3, 100mm 1 - 3HAC 14628-2
Guide pins sealing ax 2, 3, 80mm 1 - 3HAC 14628-1
Guide pins sealing ax 2, 3, 100mm - 1 3HAC 14627-3
Guide pins sealing ax 2, 3, 80mm - 1 3HAC 14627-2
Hydraulic cylinder 1 1 3HAC 11731-1
Hydraulic pump 80Mpa 1 1 3HAC 13086-1