2 Reference information
2.1.4 Standard toolkit
22 A 3HAC 16245-1
2.1.4 Standard toolkit
General All service (repairs, maintenance and installation) instructions contain lists of tools required
to perform the specified activity.
All special tools required are listed directly in the instructions while all the tools that are
considered standard are gathered in the Standard toolkit and defined in the table below.
In this way, the tools required are the sum of the Standard Toolkit and any tools listed in the
instruction.
Contents,
standard toolkit,
3HAC 15571-1
Qty Tool Rem.
1 Ring-open-end spanner 8-19mm
1 Socket head cap 5-17mm
1 Torx socket no:20-60
1 Box spanner set
1 Torque wrench 10-100Nm
1 Torque wrench 75-400Nm
1 Ratchet head for torque wrench 1/2
2 Hexagon-headed screw M10x100
1 Socket head cap no:14, socket 40mm bit L 100mm
1 Socket head cap no:14, socket 40mm bit L 20mm To be shorted to 12mm
1 Socket head cap no:6, socket 40mm bit L 145mm
To Next Page
Loading...
