4 On-site Installation
4.1.1 Lifting manipulator with fork lift
40 A 3HAC 16245-1
4. Secure the fork lift pocket vertically by
fastening the two washers and oil
lubricated securing screws to the
frame (only in fork lift set 3HAC 0604-
1!).
Shown in the figure Illustration, 3HAC 0604-
1 on page 38!
2 pcs; M16x60; tightening torque: 300 Nm
±45 Nm.
Make sure the original screws are always
used (or replacements of equivalent quality:
M16, quality 12.9)!
5. Secure the second fork lift pocket on
the other side of the manipulator with
securing screws.
Shown in figure Illustration, 3HAC 0604-2
on page 37 or Illustration, 3HAC 0604-1 on
page 38!
4 pcs; M16x60; tightening torque: 60 Nm
±12 Nm (not oil lubricated screws).
Make sure the original screws are always
used (or replacements of equivalent quality:
M16, quality 12.9)!
6. Double-check that the pockets are
properly secured to the manipulator!
Insert the fork lift forks into the pock-
ets and carefully lift the manipulator.
xx0200000380
Reposition the harness, if any, before using
a fork lift!
7. Lift the manipulator and move it to its
installation site.
Step Action Info/Illustration
To Next Page
Loading...
