ABB IRB 6660 - 130/3.1 - Page 334

NoteAction
Clean the gearbox of residual grease.13
Loctite 243.Apply locking liquid in the attachment holes
for the gearbox cover.
14
xx1000001407
Fit the o-ring in the cover.15
M8x35 quality 8.8-A2F (12 pcs)Refit the cover with its attachment screws
and washers.
Note
Fit the cover so that the arrow on the cover
points upwards!
16
Tightening torque: 24 Nm
xx1000001408
See Replacing motors, axes 2 and 3 on
page 281
Refit the motors axes 2-3.17
See Performing a leak-down test on
page 174.
Perform a leakdown test.18
Continues on next page
334 Product manual - IRB 6660
3HAC028197-001 Revision: S
© Copyright 2007-2018 ABB. All rights reserved.
4 Repair
4.7.2 Replacing the gearbox, axes 2- 3
Continued