14 PositionMaster EDP300 DIGITAL POSITIONER | CI/EDP300-EN REV. D
5 Transport and storage
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
Transporting the device
Observe the following instructions:
• Do not expose the device to humidity during transport.
Pack the device accordingly.
• Pack the device so that it is protected against vibrations
during transport, for example, by using air-cushioned
packing.
Storing the device
• The device must be stored in dry and dust-free conditions.
• Observe the permissible storage and transportation
temperatures.
• Protect uncovered metallic surfaces with a suited long-term
corrosion inhibitor.
• Observe the relevant long-term storage temperatures.
• In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
Ambient conditions
Transport and storage
Ambient temperature range −40 to 85 °C (−40 to 185 °F)
Relative humidity 75% annual average
Returning devices
Use the original packaging or a secure transport container of an
appropriate type if you need to return the device for repair or
recalibration purposes.
Fill out the return form (see Return form on page 43) and include
this with the device.
In accordance with the EU Directive governing hazardous
materials, the owner of hazardous waste is responsible for its
disposal or must observe the following regulations for shipping
purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please contact Customer Center Service acc. to page 5 for
nearest service location.
To Next Page
Loading...
