6:2.5 Event Log menu
The Event Log menu is used to check the event log in the softstarter. When entering this menu, the
twenty latest events in the log are presented, in chronological order with the latest event as No. 1,
the second latest as No. 2 etc.
The events are presented with “type of event”, date and time.
Use the navigation keys to view all entries in the event log.
6:2.6 Status Information menu
The Status information menu is used to present various information.
Use the navigation keys to cycle through the various sub menus.
If the unit is connected “inside delta”, the displayed phase currents, L1, L2 & L3 are inside delta cur
-
rent values.
Display text Function
Frequency Measured frequency
Phase seq Phase sequence indication
Connection Type of connection, In Line/Inside Delta
Phase L1 Phase current L1
Phase L2 Phase current L2
Phase L3 Phase current L3
Run time Total run time of the motor
No. of Starts Run counter
SW Ver. CU Software version CU.
SW Ver. FU Software version FU.
SW Ver KP 1
Software version External Keypad
DB Version Database version
MAC Address Internal addressing
LV Board No Serial No of the LV PCB
1 Only if connected.
6:2.7 Reset Events menu
The Reset Events menu is entered automatically when a fault has occurred or a protection is acti-
vated. It can also be entered through the main menu.
Use the navigation keys to view all events. Each event can be reset.
Figure 25: Event log menu
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Figure 26: Status information menu
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Figure 27: Reset events menu
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Chapter 6
Human-Machine Interface (HMI)
Low Voltage Products & Systems 6.7
ABB Inc. • 888-385-1221 • www.abb-control.com 1SXU 132 021 M0201
6
To Next Page
Loading...
