ABB PST210 - Page 41

7:1.1 Overview of all accessible settings (different menus)
Setting/parameter
Top
level
Application
setting
Basic
settings
Functional
settings
Presentation
settings
All
settings
Reset all
settings
Password X
Keypad lock/unlock X
Reset to factory default setting X
Application type X
Setting le X X X X
Overload class X X X X
External By-pass X X X X
Start ramp Tune Set X X X
Stop ramp Tune Set X X X
Initial voltage Tune Set X X X
End voltage Tune Set X X X
Step down voltage Tune Set X X X
Current limit Tune Set X X X
Kick start X X
Kick level X X
Kick time X X
Start range X X
Stop range X X
Overload protectcion X X
Overload start class X X
Overload run class X X
Overload operation X X
Locked rotor protection X X
Locked rotor protection level X X
Locked rotor protection time X X
Locked rotor protection operation X X
Underload protection X X
Underload protection level X X
Underload protection time X X
Underload protection operation X X
Phase imbalance protection X X
Phase imbalance protection level X X
Phase imbalance protection operation X X
High current protection X X
High current protection operation X X
Phase reversal protection X X
Phase reversal protection operation X X
PTC protection X X
PTC protection operation X X
By-pass fault operation X X
Warning high current X X
Warning high current level X X
Warning low current X X
Warning low current level X X
Warning overload X X
Warning overload level X X
Warning thyristor (SCR) overload X X
Phase loss fault operation X X
Fieldbus fault operation X X
Frequency fault operation X X
Chapter 7
Settings and conguration
Low Voltage Products & Systems 7.3
ABB Inc. • 888-385-1221 • www.abb-control.com 1SXU 132 021 M0201
7